Operation Manual

8
Product Function
Single Use
Multi- lights Use
1
2
brightness. (Shown as Figure 2)
into 30 levels from Minimum to Maximum, turn clockwise to increase brightness and turn anticlockwise to reduce
2、
After entered to steady mode, turn brightness adjustment switch to adjust LED brightness; light brightness divided
the default brightness of this light as Minimum value. (See Figure 1)
1、
Switch on the power after power-on, LCD screen lights up to show current status and enter to steady mode.Now,
can freely adjust and control each other until coding is completed.
freely. Before adjusting wireless brightness, you need to code the lights that will be needed to control. The lights
When using multi Sonnon DL-914 LED lights together, the wireless brightness for every group can be adjusted
receiver. After coding succeeded, just restart the signal transmission LED light.
LED light to complete coding. If you need to use multi LED lights together, repeat the coding setting steps of the
coding succeeded, LED screen will back to the current interface. Restart the power switch of the transmitter signal
on the power at the same time. Release the sync switch until BIND RX will be displayed on the LCD screen. After
and turn on the power at the same time. And then press and hold Group B sync switch of another light and turn
1、
First, set one LED light as transmitter for signal transmission, press an hold Group A sync switch of the LED light