Instruction Manual

BACK PLATE ASSEMBLY
Locate the bag containing the parts shown below.
Take the docking cradle, AMPS plate and L-bracket and line up
the holes as shown in the figure to the le. Be sure to line up
the plate and dock with the lowest set of holes on the
L-bracket. This will give you more clearance to remove the
assembly from the clamp mount.
Next, use the four supplied screws to aach the AMPS plate
and L-bracket to the back of the dock. Make sure the top
poron of the L-bracket is facing away from the dock so the
receiver can be mounted to the dock.
Note: Your dock may have connecons on the side.
AMPS Plate with Screws
SiriusXM™ Dock
Metal L-bracket
Pixel Technologies, Inc. | www.pixelsatradio.com | [e-mail] | [phone] | Page 2
To install the kit onto a RAM mount, use the RAM
Mount Adapter Plate located in the supplied parts
bag. Take the docking cradle, RAM mount plate and
L-bracket and line up the holes as shown in the figure
below. Be sure to line up the plate and dock with the
lowest set of holes on the L-bracket. Next, use the
four supplied screws to aach the RAM plate and
L-bracket to the back of the dock. Make sure the top
poron of the L-bracket is facing away from the dock
so the receiver can be mounted to the dock.
Note: Your dock may have connecons on the side.
RAM Mount Adapter and Screws
SiriusXM™ Dock
Metal L-bracket
Oponal - RAM Mount Assembly
Locate the bag containing the parts shown below.