Instruction Manual

ManualsBrandsPixel TECHNOLOGIES ManualsMotorcycle KitPixel TECHNOLOGIES SXMTRK17 Satellite Radio Motorcycle Kit

SXMTRK17 - Satellite Radio Motorcycle Kit

Installaon Instrucons

Pixel Technologies, Inc. | www.pixelsatradio.com | contactus@pixelsatradio.com | (800) 595-0845 | Page 1

Package Includes

(1) SiriusXM™ PowerConnect™ Vehicle Cradle

(1) SiriusXM™ 5 Volt Hardwired Power Adapter

(1) Handlebar Clamp Mount

(1) RAM Ball Mount Adapter (25 MM)

(1) SiriusXM™ Antenna

(1) Auxiliary Cable

(1) Metal L-Bracket

(1) AMPS Plate (Male Single Notch) with Screws

Loosen this screw

Rubber inserted here

Step 1 - Install Clamp Mount

Before geng started, it is important to select an installaon locaon for the protecve case with receiver.

Aer selecng the installaon locaon for the protecve case, loosen the two screws on the handlebar clamp mount

all the way out and separate it from the back side of the clamp mount. Place the clamp mount on the handlebars, line

up the screw holes and ghten the screws to mount the clamp. Use the supplied rubber strips to increase the grip of

the mount.

Summary of content (4 pages)

PAGE 1
SXMTRK17 - Satellite Radio Motorcycle Kit Installa on Instruc ons Package Includes (1) SiriusXM™ PowerConnect™ Vehicle Cradle (1) SiriusXM™ 5 Volt Hardwired Power Adapter (1) Handlebar Clamp Mount (1) RAM Ball Mount Adapter (25 MM) (1) SiriusXM™ Antenna (1) Auxiliary Cable (1) Metal L-Bracket (1) AMPS Plate (Male Single Notch) with Screws Step 1 - Install Clamp Mount Before ge ng started, it is important to select an installa on loca on for the protec ve case with receiver.
PAGE 2
BACK PLATE ASSEMBLY Locate the bag containing the parts shown below. AMPS Plate with Screws SiriusXM™ Dock Metal L-bracket Take the docking cradle, AMPS plate and L-bracket and line up the holes as shown in the ﬁgure to the le . Be sure to line up the plate and dock with the lowest set of holes on the L-bracket. This will give you more clearance to remove the assembly from the clamp mount. Next, use the four supplied screws to a ach the AMPS plate and L-bracket to the back of the dock.
PAGE 3
Step 3 - Connect Mount and Mount Antenna To connect the assembly to the clamp mount, slide the single T-notch on the clamp mount up into the slot on the AMPS plate. Secure the pivot by ghtening the lock ring. Next, place the antenna on the metal L-bracket and wrap the excess cable around the L-bracket or e wrap it around the base. It is recommended to leave some excess play in the cable. Lock Ring Fully Assembled Step 4 - Connect Power Included in the package is a hardwired power adapter.
PAGE 4
Step 6 - Connec ng Docking Cradle A er all cables have been run, connect each cable to the corresponding port on the dock. (Some docks may have the connec ons on the sides and not the back as shown in the ﬁgure below) Audio Port Antenna Port Power Port FM Port Note: If installing a Bluetooth SiriusXM™ Dock, only power and antenna are required. The FM port on the dock is not used unless installing the FMDA25 Direct Wire Audio Adapter.