Installation Guide

FOREWORD
Thanks for choosing LUMI II series studio flash. It is a durable and good
quality strobe with complete functions to help photographers create desired
lighting effects. The product is suited for wedding, portrait, and product
photography. The LUMI II flash offers:
Built-in PIXAPRO 2.4G wireless ST-III System
Precise output displayed on LCD panel, 50 steps from 1/32 to 1/1 (or 5.0-10.0) in
0.1 increments
High-qualified modeling lamp, 150W output and 5% to 100% manual light
adjustment
Outstanding output stability, a tolerance of ≤ 2% under the same output
Anti-preflash function, enabling synchronization with cameras having a one-
preflash firing system
Adjusted parameters intelligently remembered after 3s and automatically
recovered after a restart
Wireless control of the flash power ratio, the on-and-off of modeling lamp and
buzzer, as well as flash triggering with PIXAPRO ST-III, ECO 2.4 or PRO AC
2.4GHz flash trigger
CONTENTS
07 • Slave Trigger Model
07
• Buzz Function
07
• Key Combination
07
• Alarm Display
07
• Memory Function
08
• Wireless Control Function
09
• Tube Replacement
10 Technical Data
10 Maintenance
To prevent damage to the product or injury to you or to others, read the
following warnings in their entirety before using this product. Keep these
safety instructions where users can read them for ready reference.
Do not disassemble or modify. Should the product break down, send the
defective back to the authorized service center for inspection and maintenance.
Keep dry. Do not handle with wet hands, immerse in water, or expose to rain.
Keep out of reach of children.
Please put the device in a ventilation environment and keep the parts of lighting
and heat dissipation holes are unobstructed. Do not use in flammable
environment.
As this product adopts make and break device, please keep it easy to be used.
No touching the heating parts of this product.
Please turn off the power and wear insulated gloves before installing and
connecting accessories. When replacing the tube or modeling lamp, please
make sure that the tube is cool and wear insulated gloves to prevent burns.
Do not flash directly towards naked eyes (especially those of babies), otherwise
it may lead to visual impairment.
Disconnect from the power supply when it will not be used for an extended
period.
CAUTION
After 30 continuous flashes at full power, the flash should be cooled down for
about 3 minutes. Overheating will occur if it is used continuously without cooling
down.
Do not keep using the modeling lamp for a long time; otherwise flammable
accessories attaching to flash head, e.g. softbox will get burnt. A 10-minute time
is recommended in this case. After 10 minutes, cool it down for 1 minute.
When using a snoot, do not keep the modeling lamp on for a long time or fire too
frequently (not over six times for one minute). Overheating will result in damages
for strobe housing and/or studio light.
Avoid sudden impacts as this can damage the flash tube and/or modeling lamp.
01 Foreword
02 Warning
02 Caution
03 Names of Parts
03
• Body
04
• LCD Panel
04
• Accessories
04 Separately Sold Accessories
05 Operations
05
• Flash Preparation
05
• Power Connection
05 • Modeling Lamp
06
• Power Output Control
06
• Test Button
06
• Sync Triggering
06
• GR/CH Button
- 02 -- 01 -
Warning