Instructions / Assembly

2.14 Layout four 6 inch x 8 inch glass blocks, three ARQUE
®
blocks and one 6 inch x 8 inch EndBlock
™
Finishing Unit. Vertical spacers needed are: four 7
1
/
2
inch vertical
spacers and four ARQUE
®
vertical spacers. Horizontal spacers needed are: one 23
3
/
8
inch horizontal spacer, three ARQUE
®
horizontal half spacers and one 4
7
/
8
inch
horizontal spacer. Insert wall anchor into the first 23
3
/
8
inch horizontal spacer. Temporarily install the horizontal spacers on to curb, one 23
3
/
8
inch horizontal spacer
with anchor, three ARQUE
®
horizontal half spacers with tabs removed (bend barb tab back and forth until it snaps off) and one 4
7
/
8
inch horizontal spacer.
2. GLASS BLOCK INSTALLATION
(Walk-In shower – Curved wall section)
2.16 Install one 6 inch x 8 inch EndBlock
™
Finishing Unit after the last ARQUE
®
vertical spacer. Carefully adjust these blocks to fit the curb and then carefully remove the
glass blocks from the bottom horizontal spacers (do not move the bottom spacers).
2.17 Next, mark the location of the horizontal spacers on the curb. Reinstall first horizontal spacer and four 6 x 8 inch glass blocks with sealant following the procedures
in the straight wall section. Next apply a
1
/
2
inch bead of sealant around the inside perimeter of the markings on the curb for the first ARQUE
®
glass block.
2.15 Temporarily install glass blocks on horizontal spacers. Start with a 7
1
/
2
inch vertical spacer, four 6 inch X 8 inch glass blocks with 7
1
/
2
inch vertical spacers
between the glass blocks and three ARQUE
®
glass blocks starting with an ARQUE
®
vertical spacer and ending with an ARQUE
®
vertical spacer (thick part of the
spacer towards the outside).
-7-