Instructions / Assembly

2.9 Level all the glass blocks. Be sure to slide the wedges between the horizontal spacers and shower base not between the glass block and the horizontal spacer.
2.10 Next, apply
1
/
2
inch beads of sealant to the top of the installed glass blocks behind the raised edge of the glass block faces on both sides of the blocks.
Next, install the second horizontal spacer with anchor inserted and push the spacer firmly in place. Install two screws in the anchor (use the screws provided
with anchors).
2.7 Apply
1
/
2
inch dabs of sealant behind the raised edge of the glass block face
1
/
2
inch in from the four corners, then press another vertical spacer into place.
Apply four
1
/
2
inch dabs of sealant to the vertical spacer
1
/
2
inch in from the four-corners. Install the second glass block with sealant side down.
2.8 Now, that the first course is installed you will need to level the glass blocks using the wedges provided with the anchors. Place a level on top of the first glass
block. If the glass block is not level, carefully slide the tip of a screwdriver (straight tip) under the horizontal spacer until the glass block is level. Next, slide a
wedge under the horizontal spacer.
-5-