User's Manual

5
PITTASOFT
Getting Ready
Checking the main body of the Pitta 310
Check the main body of the Pitta 310.
✎ Description is based on Pitta 310W / 310WR.
✎ The figures presented may differ from the actual appearances of the product.
1
Front LED
Red: Booting Orange: Starting
Green: Operating Red blinking: Firmware upgrading
2
AUDIO IN/OUT
IN: Audio input port. You can connect a microphone.
(Check the sound with a PC)
OUT: Audio output port. You can connect a speaker. (This feature is not
LPSOHPHQWHG,WZLOOEHH[SHFWHGWRDGGWKLVIHDWXUHDIWHU¿UPZDUH
upgrade.)
3
WIRELESS ON/
OFF
Wireless ON/OFF switch. Make sure that the switch is ON if wireless
needs.
4
ANTENNA Wireless port. Connect the antenna for wireless installation.
5
LAN
Connect the 10/100 Mbps Ethernet cable. Make sure that use RJ-45
connector. Supports PoE (IEEE 802.3af)
6
RESET
Press the reset button for 3 seconds then all the settings will be changed
to initial settings.
7
DC IN DC 5V / 1.0A power terminal.
8
NETWORK LED LED is blinking when network is connected.
9
POWER LED LED is blinking when power is on.
0
Built-in microphone Built-in microphone location.
1 2 3
567
8 9 0
4