User's Manual
25
PITTASOFT
ⵒ Camera Firmware Upgrade
How to upgrade the camera frimware
'RZQORDGXSGDWHG¿UPZDUH¿OHIURP
support menu in Pittasoft homepage
(www.pittasoft.com).
2. Click 'Open' button and then select the
XSGDWHG¿UPZDUH¿OH
3. Click 'Upgrade' button. Upgrade will
run automatically
✎ Red LED will be flashing on the front of the
camera during upgrade.
✎ The upgrade time takes up to 10 minutes.
✎ You must not turn off the camera during
upgrade. The camera will automatically restart when upgrade is completed.
4. Upgrade is completed. Press OK button
5. Reconnect to Pitta WebView.
Make sure that the upgrade is complete properly.
✎ When you are accessing this page for the first time, a yellow bar will appear at the top of the
screen. Click on the yellow bar to continue to install the 'FWUpgradeX Module'.
✎ After firmware is upgraded, all the settings will be changed to initial setting including IP
address.
❚ About
This page contains current Pitta WebView
YHUVLRQ¿UPZDUHYHUVLRQDQGWKHVHULDO
number.
&KHFNWKH¿UPZDUHYHUVLRQ