User's Manual

8
PITTASOFT
Getting Ready
Connecting Pitta 310
❚ For wireless camera
To connect the wireless camera, IP setting and wireless setting must be set before using.
Once set up is done, disconnect the LAN cable and connect the wireless camera.
1 Connect the camera with the LAN cable.
(T page 7)
2 Set IP address. (T pages 12~13)
3 6HWZLUHOHVVFRQ¿JXUDWLRQLQ3LWWD:HE9LHZ
(T page 19)
4 Disconnect the LAN cable.
5 Connect the antenna.
6 Turn on the WIRELESS switch.
✎ Make sure that NETWORK LED is blinking after
about 1 minute.
7 Disconnect and reconnect the AC adaptor. The
camera will reboot.
8 Check the IP address with the Pitta IP Utility.
✎ If the connection is change to wireless, IP address may change and the router may need to
restart.