User's Manual

DR650S-2CH 13
Turn on the engine. The BlackVue dashcam will power up and start recording. Video
files are stored on the microSD card. When the microSD card fills up, the newest
video les will start to replace the oldest video les (called loop recording) – so you
will always have the most recent video les.
Note
y
The recording LED blinks while recording (default setting) and the GPS LED is
on when a GPS signal is received. There are 4 recording modes: Normal, Event,
Parking and Manual. The dashcam starts recording in normal mode, switches to
event mode when an impact is detected, and switches to parking mode if the
vehicle is stationary for 10 minutes. Touching the manual recording proximity
sensor will start a manual recording.
y
When you run the dashcam for the rst time the rmware is automatically loaded
onto the microSD card. After the firmware has been loaded onto the microSD
card you can customize settings using BlackVue Viewer on a computer.
Turn off the engine. The dashcam will automatically stop recording and power
down. To record in parking mode while the engine is off please install a Power
Magic Battery Pack (sold separately) or a Power Magic Pro (sold separately). A
Power Magic Pro powers your dashcam when the engine is o by hardwiring it to
the automotive battery. A low voltage power cut-o function and a parking mode
timer protect the automotive battery from discharge.