Front Side Installation Manual

EN
11. Slide the unit carefully into position
until the gas taps are vertically aligned
with the cutouts in the front frame (or
blende).
21. The unit is now ready for use.
10. Note: the adhesive strip under the
sealing scale of the knob may not yet be
removed.
13. Correct centered gas taps.
12. Tighten the set screws from the back
to the front until the gas taps are centered
with the cutouts. Check that all screws are
tightened.
!
16. Check whether the knobs stick out
sufficiently. The knobs should have a
distance of 13-15 mm above the sealing
scales.
17. Check that the knobs turn smooth-
ly and return to the rest position after
pressing. If necessary, remove the sealing
scale and replace them again.
18. Connect the unit to gas and electricity
and ignite the burners. If the flames go
out after ignition, the knobs have to be
adjusted again (step 9).
15. Remove the adhesive strip from the
sealing scale. Press the knob and the
sealing scale as a one on the gas tap, so
that they are centered and aligned.
!
14. Measure the distance between the
front of the unit and the front frame (or
blende) again. This distance must be 75
mm.
75 mm
20. Support the unit with the double
PITT
®
cooking support set. (see enclosed
installation instructions)
!
13-15mm
19. Check that the heat conductor makes
full contact with the worktop.
!
Installation FS 2019 NL-EN-FR-DE-ES-IT EU PC 2 combi.indd 7 4-4-2019 17:59:58