Inc. Printer User Manual

Pitney Bowes W660/W680 Operator Guide 2-5
Setting Up the W660/W680 Printer • 2
Follow these guidelines and safety precautions when selecting a
location for your printer.
• Place the printer on a table or other stable, level surface
within the cable's length (Parallel 10 feet max. - Serial 15
feet max.) of your computer.
• Allow for adequate space. The W660/W680 is 14.7 inches
high, 16.2 inches wide and 21.7 inches deep, without the
wire frame input stacker.
• Allow for adequate ventilation around the base and rear
of the printer.
• Protect the printer from heat, dust and moisture. Avoid
placing the printer in direct sunlight.
• To protect against electric shock, plug the machine into a
properly grounded wall outlet. DO NOT use an adapter
plug. Use of an adapter could compromise the ground
and cause a possible shock hazard or damage to the
equipment in the event of a short circuit.
• DO NOT remove the ground pin from the line cord.
• Avoid using outlets controlled by wall switches. Someone
could accidently shut your printer off.
• The power cord wall plug is the primary means of
disconnecting the machine from the AC power. The wall
outlet should be near the machine and easily accessible.
• DO NOT route the power cord over sharp edges or trap
it between pieces of furniture.
• Insure that there is no strain on the power cord where it
passes between the equipment, walls or furniture.
• Be certain the area in front of the wall receptacle into
which the machine is plugged is free from obstruction.
Choosing a
Location for
Your Printer
Important
Safety Notes