- LPS-1LABEL PRINTER USER GUIDE

APPENDIX
58
Maintenance
Changing Cutter Unit
Repeated use of the cutter unit will eventually reduce the sharpness of the blade. When this occurs,
purchase replacement blades and then follow this procedure to replace the cutter. Refer to
Accessories on page 61 for details on purchasing replacement blades.
1 Turn off the LPS-1 and unplug the power code from the electrical outlet.
2 Open the LA Roll compartment cover, lift up the label
lever, and remove the LA Roll from the compartment.
3 Using a screw driver, loosen the screw securing the
cutter unit.
4 Grip the tab and lift out the cutter unit.
5 Press the new cutter unit in the machine with the two holes aligned with the to posts in
the machine.
6 Tighten the screw securing the cutter unit.
7 Install the LA Roll and close the LA Roll compartment cover.
For details refer to “Installing the LA Roll” on page 8.
8 Plug the power cord back into the electrical outlet.
The screw securing the cutter unit cannot be completely
removed. Simply loosen it to remove the cutter unit from the
LPS-1.
Be very careful not to touch the sharp edge of the cutter.