- LPS-1LABEL PRINTER USER GUIDE

57
z APPENDIX
Maintenance
4 Thread the end ( ) of the Cleaning Sheet into the slot
immediately before the cutter.
5 After the Cleaning Sheet is inserted in the slot, peel of
section ( ) of the sheet.
6 Turn on the LPS-1.
7 Press and hold the FEED button for at least one second.
The roller rotates for 4" (10 cm).
8 The adhesive surface of the Cleaning Sheet removes any dirt and lint from the roller,
and cleaning is then completed. A Cleaning Sheet can only be used one time.
• Do not peel off section ( ) of the sheet.
• Make sure that the printed surface of the Cleaning Sheet is
facing up.
1
1
2
• The length of the Cleaning Sheet is 3" (8.5 cm).
• Pressing the FEED button for less than one
second makes the roller rotate for 1/3" (8 mm)
only.