- LPS-1LABEL PRINTER USER GUIDE

19
z INSTALLING SOFTWARE
Installing the Software
8 When the Driver Setup dialog box
instructs you to connect the LPS-1,
plug the connector on the USB cable
into the USB port on the back of the
LPS-1.
9 Check that the LPS-1 is turned on, and
then plug the connector on the USB
cable into the USB port on your
personal computer.
The Add New Hardware Wizard dialog box
appears.
10 Click [Next].
The next Add New Hardware Wizard
dialog box appears.
11 Click [Next].
The next Add New Hardware Wizard dialog
box appears.
When connecting the LPS-1 to a personal
computer via a USB hub, a proper
connection may not be possible due to the
type of hub used. If this occurs, connect the
LPS-1 directly to the personal computer.
The name of the detected hardware shown
in the dialog box may vary depending on
your operating environment.