- LPS-1LABEL PRINTER USER GUIDE

9
z GETTING STARTED
Installing the Paper Guide
3 Lift the label lever and then thread the end of the LA Roll
into the slot immediately before the cutter.
4 Lower the label lever and then close the LA Roll
compartment cover.
Your LPS-1 comes with a paper guide that collects a strip of printed labels that have been printed
and not yet cut off from the machine.
1 Attach the paper guide to the front of the LPS-1 as
shown in the figure.
When unable to thread the end of the LA Roll to the slot,
thread it as far as possible, lower the label lever and close the
cover, then press the FEED button to set the roll.
Installing the Paper Guide
Remove the paper guide when printing more than 10 labels
continuously.