- LPS-1LABEL PRINTER USER GUIDE

7
z GETTING STARTED
Connecting to the Power Supply
1 Plug the power supply cord into a standard electrical
outlet.
Connecting to the Power Supply
• Check that the electrical outlet is 120 V before inserting the
plug.
• Remove the power supply cord from the electrical outlet
after you have finished using the LPS-1.
• Do not pull the cord when removing it from the electrical
outlet. The wire in the cord may become damaged.
Do not connect the LPS-1 to the USB port of your personal computer yet.
Do not connect the LPS-1 to your personal computer until
directed to do so when installing the printer driver. If the LPS-1
is connected to a personal computer that does not have the
printer driver software installed, the dialog box shown here will
appear. Click [Cancel], remove the USB cable, and then install
the printer driver software.
Refer to “Installing the Software” on page 11.