Pro-Mark Printer Operator's Handbook

3. Insert the roll of labels between the supply holders inside
the printer.
4. Use the handles on the supply holders to press the supply
holders together until they fit snuggly against the supply roll.
Make sure the supply holders are pressed against the supply
roll. Also, make sure the supply roll turns freely in the supply
well.
5. When using continuous label stock, remove a few inches of
labels from the backing paper. Cut away the labels, leaving
the backing paper attached to the roll. Be sure the labels
have a square, straight edge. Feed the backing paper over
the peel bar and through the lower opening of the label
guide. Make sure the leading edge of the label is one inch
to two inches behind the black platen roller. Otherwise, the
ribbon can be pulled out along with the labels, causing a
jam.
When loading die-cut label stock, remove a few inches of
labels from the backing paper. Feed the backing paper
over the peel bar and through the lower opening of the label
guide.
Peel
Bar
Supply
Holder
Supply
Lower
Opening
Spacer
Pinch
Rollers
Label
Guide
Upper
Opening
J640 Operator’s Handbook
2-8