Pro-Mark Printer Operator's Handbook

DO NOT wrinkle or crush the ribbon.
5. With the teeth end of the take-up reel facing down, place
the ribbon roll on the spool with the foam washer (on the
half of the cassette with the latches).
6. Feed the ribbon around the guides and place the take-up
reel onto the shorter spool.
7. Twist the ribbon roll back and forth as you firmly push it
down until it is seated on the spool.
Do not force the ribbon roll down onto the spool; you could
damage the foam washer. Also, make sure the preprinted side
of the ribbon faces out. Make sure the latches are still in the
unlocked position ( ) before fitting the two halves of the
cassette together.
Take-up
Reel
Teeth End of
Take-up Reel
Latch
Gear
Ribbon
Roll
Spool
Foam
Washer
Latch
Chapter 2. Loading Ribbon and Supplies
2-5