User guide

E700/E702 METERS

does not display

1. ZIP code not installed or inspection required. Press Refill and enter

$0.00 to allow Pitney Bowes to install your ZIP.

2. Out of ink. Use function to

install a new ink cartridge.

You do not have enough money in your account at the Data Center to

pay for the refill amount. Perform refill procedure for smaller

amount or contact Pitney Bowes to add to

your account.

No ZIP has been installed in the meter by the Data Center. Perform a

refill to install the ZIP. Press Refill. If you do not want to add

funds at this time, set the refill amount to $0.00.

Data Center connection could not be made. Repeat call. It may have

been a busy signal. If unsuccessful, check the Pitney Bowes Phone

Number and any dialing prefix you may have added in the

Setup Option.

The card is inserted incorrectly. Remove card and reinsert with the

gold circle face up and toward the bottom.

Data Center was disconnected before the refill transaction completed.

Press yes to repeat the call.

A busy signal was detected. Repeat call. If unsuccessful, check the

Pitney Bowes Phone Number and any dialing prefix you may

have added in the Setup Option.

An incorrect lock code has been entered. Press Clear (C); key in code

again. If you cannot remember the correct code, call Pitney

Bowes.

No refill has been performed for 90 days. Press Refill. If you do not

want to add funds at this time, set the refill amount to $0.00.

INSPECTION DUE-REFILL REQUIRED

INCORRECT CODE

CHG PB PHONE #

DATA CENTER PHONE IS BUSY

CONNECTION LOST-TRY AGAIN?

CANNOT READ CARD

CHG PB PHONE #

CANNOT REACH DATA CENTER

CANNOT FIND ZIP - REFILL REQUIRED

ACCOUNT BALANCE LOW

INSTALL INK CARTRIDGE?

READY