IMPORTANT FOR FUTURE REFERENCE Please complete this information and retain this manual for the life of the equipment: Model #: __________________________ Installation and Operation Manual Covering Models P90, P90K, P90KL L20-270 Rev.
TO THE PURCHASER, OWNER AND STORE MANAGER Please review these warnings prior to posting them in a prominent location for reference. WARNING DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. WARNING Improper installation, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this appliance.
TABLE OF CONTENTS ASSEMBLY............................................................................................................................. 3 OPERATION ........................................................................................................................... 3 CLEANING.............................................................................................................................. 3 TROUBLESHOOTING .....................................................................
ASSEMBLY Place the Paper Support Rack inside the filter envelope so that the threaded coupling fits into the hole cut in the top of the paper. Fold the open end of the filter envelope over two times and push the Clip over folded end of filter envelope. Thread the Pick Up Tube onto the threaded coupling and hand tighten. Insert filter envelope assembly into filter pan and connect the Pick Up Tube Union to the Pump assembly. Sprinkle filter powder over filter envelope assembly, if desired.
TROUBLESHOOTING Pump does not run Check circuit breaker Pump does not run, power is present at the machine, circuit breaker is NOT tripped Pump is running, but oil is not being pumped Check the motor overheat trip switch located on the end of the motor Check for blockages in piping and return hose Air bubbles are present when oil is being pumped There is an air leak on the suction side of the pump, check filter connections SCHEMATICS L20-270 Rev.
This page Intentionally left blank 5 L20-270 Rev.
This page intentionally left blank L20-329, 6 R2 (05/11) L20-270 R1 (06/11)
In the event of problems with or questions about your order, please contact the Pitco Frialator factory at: (603) 225-6684 World Wide In the event of problems with or questions about your equipment please contact the Pitco Frialator Authorized Service and Parts Representative (ASAP) covering your area or contact Pitco at the numbers listed to the left. MAILING ADDRESS – P.O. BOX 501, CONCORD, NH 03302-0501 SHIPPING ADDRESS – 10 FERRY ST., CONCORD, NH 03301 L20-270 Rev.
