Pit Boss® Pro Series Manual

ManualsBrandsPit Boss ManualsCombo Grills12.5-fl oz Hand Soap

ENGLISH

panel of the main barrel. Slide the notched end of the adjusting bar into

the raised tab on the flame broiler slider, giving you adjustable access to

the slider on the main plate.

NOTE: When the flame broiler slider is open, and direct flame is used

while cooking, do not leave the grill unattended for any period of time.

• Place the cooking grids, side-by-side, on the grid ledge inside the main grill.

Place the upper cooking rack on the upper ledge inside the main grill. The

cooking rack will lock into place.

IMPORTANT: To maintain optimal searing and grilling performance of

your cooking grids, regular care and maintenance is required.

25.    /

Parts Required:

1 x Grease Bucket

(#22)

1 x Grease Tray

(#25)

Installation:

• Slide the grease tray into the bottom of the barrel.

• Place the grease bucket on the spout hook on the bottom of the main

barrel. Ensure it is level to avoid grease spills.

• The unit is now completely assembled.

26.     

NOTE: Before plugging your Pit Boss into any electrical outlet, ensure the

temperature dial is in the OFF position.

•

 

This appliance requires 120 volt, 60hz, 250W, 5 amp service. It must be a

3-prong grounded plug. Ensure grounded end is not broken off before use.

The control uses a 5 amp, 120 volt, fast-blow fuse to protect the board from

the igniter.

•

 

This appliance will work on most GFCI outlets, with a recommended size

of 15 amp service. If your GFCI outlet is highly sensitive to power surges,

it will likely trip during the start-up phase of operation. During the start-

up phase, the igniter draws 200-700 watts of electricity which can be too

much power for a GFCI outlet to handle. Each time it trips, it increases in

sensitivity. If the GFCI keeps tripping, replace the outlet or change to a non-

GFCI outlet.

•

  

Disconnect the igniter from the main wiring harness. Use the manual start-

up procedure. A Pit Boss unit can operate using a 12 volt, 100 watt inverter

plugged into your automobile outlet. To use the automatic igniter, it is

recommended to use a minimum of a 1000 watt inverter.

IMPORTANT: Disconnect unit from power source when not in use.

 ,

5 

24