Pit Boss® Pro Series Manual

ENGLISH
10
6.      
Parts Required:
2 x Wheel
(#33)
2 x Wheel Axle Pin
(#G)
2 x Wheel Washer
(#F)
2 x Wheel Cotter Pin
(#E)
Installation:
Attach the large wheel to the support leg by inserting the wheel axle pin
through the wheel. Support leg hole, then secure using the wheel cotter
pin. Repeat installation for the other wheel on same side.
7.       
Parts Required:
2 x Locking Caster Wheel
(#32)
Installation:
Insert each locking caster wheel into the bottom of each support leg by
hand-tightening into the hole. It will secure into the self-clinching nut.
Ensure the locking caster wheel is inserted completely by ensuring it
cannot rotate any further.
Once the wheels are secure, lock the caster wheels, then using a second
person, carefully lift the grill into an upright position.
IMPORTANT: Re-tighten the support leg screws to ensure they are
completely secure after positioning the grill upright.
8.    
Parts Required:
1 x Lid Stopper
(#8)
Installation:
Secure the lid stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.
9.   
Parts Required:
1 x Chimney Cap
(#6)
1 x Chimney Stack
(#9)
3 x Screw
(#A)
3 x Locking Washer
(#C)
3 x Washer
(#B)
3 x Nut
(#I)
Installation:
Locate the chimney opening on the backside of the gas barrel. From the
inside of the gas barrel, insert the chimney stack through the opening.
Insert a washer, locking washers, and screw into each hole from the outside
of the gas barrel, but fasten only half-way, Once all three screws are partially
installed, secure the screws completely.
7
32
6
33
33
8
8
8
9
6
9