Instructions / Assembly

20
wood chips tray the fastest and also give you the Highest Temperatures inside your smoker.
2019
17
Operating Instructions
Operating Instructions
18
LIGHTING INSTRUCTION:
READ ALL INSTRUCTION BEFORE LIGHTING.
OPEN DOOR DURING LIGHTING.
OPEN CYLINDER MAIN GAS VALVE.
PUSH AND TURN BURNER VALVE COUNTER-CLOCKWISE TO
TO “HIGH” POSITION " ".
PUSH IGNITOR BUTTON UNTIL BURNER IGNITES.
IF IGNITION DOES NOT OCCUR WITHIN 5 SECONDS, TURN VALVES
O
TO OFF POSITION " ", WAIT 5 MINUTES, AND REPEAT
LIGHTING PROCEDURE.
Install LP-Cylinder
on the unit as
shown below
OPERATING INSTRUCTIONS
Operating Instructions for Dual Burner System
Your Pit Boss Gas Smoker was designed with a
Single Valve Control/ Dual Burner System. The
Top burner is a low BTU smoke burner and the
bottom Burner is a Higher BTU main burner. The
following is the recommended operation:
1. When the control knob is set to the
setting, both burners lit. This will give you smoke from your
HIGH
2. When the control knob is set to the MED setting, both burners are still lit. The main Burner is on
3. When your control knob is set to the “Low”
automatically Shut off. This will give you smoke from your wood chips tray in approx. 10min depending on how long you
soaked your wood chips. This will also give you lowest temperature inside your smoker.
4. If you have your control knob set on “Low” setting and desire higher temperature, you must rotate your control knob
90 degree to the “MED” setting to the “High” setting.
FLAME OPERATION INSTRUCTIONS:
TURN BURNER VALVE TO “LOW” POSITION " " IF NEEDED.
TURN BURNER VALVE “HIGH” POSITION " " IF NEEDED.
TURN BURNER VALVE “OFF” POSITION " ". IF NEEDED.
O
Note: Use the viewing holes on the sides of the smoker
Support Panel to make sure both burners flames are lit.
Smoke Burner
Main Burner
-------
-----------
Low
setting, only the smoke burner will be lit. The main burner will
---
HIGH setting
Med
the “Low” setting and the smoke burner is on. This will give you smoke from your wood chips tray quickly and give you the
intermediate temperature range inside your smoker.
--
---
LP Cylider Capacity and Specifications:
The 20 lb (9.1 kg). LP cylinder used with this smoker must conform to the following requirements.
Diameter- 12” (30.5cm)
Height 18” (45.7cm)
WARNINGS
Keep the fuel supply hose away from any heated surface
The use of alcohol, prescription or non-prescription drugs may impair the consumer's ability to
properly assemble or safely operate the appliance.
Cylinders must be stored outdoors out of the reach of children and shall not be stored in a building,
garage or any other enclosed area.
This appliance is not intended for and should never be used as a heater.
This appliance will be hot during and after use. Use insulated oven mitts or gloves for protection from
hot surfaces.
If the appliance is not in use, the gas must be turned off at the supply cylinder.
The pressure regulator and hose assembly supplied with the appliance must be used. Replacement
pressure regulators and hose assemblies must be those specified by the appliance manufacturer.
---------------------------------
------------------------------------
Important Note: If you need to replace or reinstall the
burner, make sure the valve tip is completely inside
burner venturi at end of burner as shown. Failure to
follow these instructions could result in fire or
explosion which could cause property damage,
personal injury or death.
wood chips tray the fastest and also give you the Highest Temperatures inside your smoker.
2019
17
Operating Instructions
Operating Instructions
18
LIGHTING INSTRUCTION:
READ ALL INSTRUCTION BEFORE LIGHTING.
OPEN DOOR DURING LIGHTING.
OPEN CYLINDER MAIN GAS VALVE.
PUSH AND TURN BURNER VALVE COUNTER-CLOCKWISE TO
TO “HIGH” POSITION " ".
PUSH IGNITOR BUTTON UNTIL BURNER IGNITES.
IF IGNITION DOES NOT OCCUR WITHIN 5 SECONDS, TURN VALVES
O
TO OFF POSITION " ", WAIT 5 MINUTES, AND REPEAT
LIGHTING PROCEDURE.
Install LP-Cylinder
on the unit as
shown below
OPERATING INSTRUCTIONS
Operating Instructions for Dual Burner System
Your Pit Boss Gas Smoker was designed with a
Single Valve Control/ Dual Burner System. The
Top burner is a low BTU smoke burner and the
bottom Burner is a Higher BTU main burner. The
following is the recommended operation:
1. When the control knob is set to the
setting, both burners lit. This will give you smoke from your
HIGH
2. When the control knob is set to the MED setting, both burners are still lit. The main Burner is on
3. When your control knob is set to the “Low”
automatically Shut off. This will give you smoke from your wood chips tray in approx. 10min depending on how long you
soaked your wood chips. This will also give you lowest temperature inside your smoker.
4. If you have your control knob set on “Low” setting and desire higher temperature, you must rotate your control knob
90 degree to the “MED” setting to the “High” setting.
FLAME OPERATION INSTRUCTIONS:
TURN BURNER VALVE TO “LOW” POSITION " " IF NEEDED.
TURN BURNER VALVE “HIGH” POSITION " " IF NEEDED.
TURN BURNER VALVE “OFF” POSITION " ". IF NEEDED.
O
Note: Use the viewing holes on the sides of the smoker
Support Panel to make sure both burners flames are lit.
Smoke Burner
Main Burner
-------
-----------
Low
setting, only the smoke burner will be lit. The main burner will
---
HIGH setting
Med
the “Low” setting and the smoke burner is on. This will give you smoke from your wood chips tray quickly and give you the
intermediate temperature range inside your smoker.
--
---
LP Cylider Capacity and Specifications:
The 20 lb (9.1 kg). LP cylinder used with this smoker must conform to the following requirements.
Diameter- 12” (30.5cm)
Height 18” (45.7cm)
WARNINGS
Keep the fuel supply hose away from any heated surface
The use of a
lcohol, prescription or non-prescription drugs may impair the consumer's ability to
properly assemble or safely operate the appliance.
Cylinders m
ust be stored outdoors out of the reach of children and shall not be stored in a building,
garage or any other enclosed area.
This appliance is not intended for and should never be used as a heater.
This applian
ce will be hot during and after use. Use insulated oven mitts or gloves for protection from
hot surfaces.
If the appli
ance is not in use, the gas must be turned off at the supply cylinder.
The pressure regulator and
hose assembly supplied with the appliance must be used. Replacement
pressure regulators and hose assemblies must be those specified by the appliance manufacturer.
-
-
-
-
-
-
-
-
-
-
-
--
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
--
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
--
-
-
-
-
-
-
-
-
-
Important Note: If you need to replace or reinstall the
burner, make sure the valve tip is completely inside
burner venturi at end of burner as shown. Failure to
follow these instructions could result in fire or
explosion which could cause property damage,
personal injury or death.