User Manual

using three screws. Note illustration 4.

NOTE: When aligned properly, the main grill should be sitting level

and secure on the cart.

• Replace large diffuser plate in main barrel, and secure using previously

removed four screws. Note illustration 4.

5.    

Parts Required:

1 x Lid Stopper

(#11)

Installation:

• Secure the lid stopper onto the top of the main barrel using the pre-

installed screw on the top of the main barrel.

6.    

Parts Required:

1 x Lid Handle

(#7)

2 x Lid Handle Bezel

(#6)

Installation:

• Remove the pre-installed screws from the lid handle. From inside the

barrel lid, insert one screw to protrude to the outside. Add a bezel on

the screw, then hand-tighten the screw (from the inside) into the lid

handle. Repeat for the other side.

7.   

Parts Required:

1 x Thermometer Kit

(#10)

Installation:

• Remove the pre-installed nut from the thermometer.

• Insert the thermometer into the hole provided on the top of the lid on

the main barrel, then secure by re-installing the nut from the inside.

Rotate the thermometer so the text is level and upright.

NOTE: If rotation is askew, this will result in incorrect readings.

8.    

Parts Required:

1 x Grease Bucket

(#12)

Installation:

• Unscrew the six screws along the outside of the hopper that secure

the hopper safety screen to the interior, and remove the safety screen

to access the grease bucket. Replace the hopper safety screen, and re-

install the six screws to secure. Note illustration 8.

• Place the grease bucket on the spout hook on the end of the main

barrel. Ensure it is level to avoid grease spills. Note illustration 8.

8

8

4