User Manual

7
 
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Before assembly of product, review all parts and reference the parts
list. If any part is missing or damaged, do not attempt to assemble. Shipping damage is not covered under warranty. Contact your
dealer or Pit Boss Customer Service for parts.
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly: screwdriver and level. Tools not included.
 
NOTE: For all of the following steps, do not tighten any screws completely until all screws for that step have been
installed. Once all screws have been installed, then tighten them securely.
1.    
Parts Required:
2 x Support Leg Foot (#14)
2 x Support Leg for Locking Caster Wheel (#15)
2 x Support Leg for Wheel (#16)
1 x Bottom Shelf (#22)
4 x Screw (#A)
4 x Locking Washer (#C)
4 x Washer (#B)
6 x Screw (#G)
Installation:
• Secure one support leg foot to the bottom of a support leg for locking
caster wheel using three screws. Repeat installation for other support leg
foot. Next, place a piece of cardboard on the floor to prevent scratching
the unit and parts during assembly. Prepare the four support legs for
installation, arranging the labelled legs as shown in illustration 1.
IMPORTANT: The four support legs must be arranged correctly to be
able to properly install the cart support plates in a later step.
• Attach the bottom shelf to one support leg by carefully aligning it into
the slotted corner of the support leg, then secure using one screw.
Repeat installation for the other three support legs to the remaining
three corners of the bottom shelf. Note illustration 1.
NOTE: Ensure the flat surface of the bottom shelf is facing up.
• Once the shelf is secure, lift the cart frame into an upright position.
2.   
Parts Required:
2 x Long Support Plate (#20)
2 x Short Support Plate (#21)
16 x Screw (#H)
1
151
152
161
162
1
151
152
161
162
2
  