User Manual
Lighting the Main Burners:
CAUTION: The cylinder valve should always be in the off, or closed position when the grill is not in use.
Good
Flame
Bad
Flame
Yellow
Blue
Observe the proper burner flame.
It should be a blue/yellow color about 1/2”
long.
● Always open the Lid before lighting the grill.
● All burner knobs should be in the "OFF" position.
● Slowly Open the LP Gas Cylinder valve,1-1 1/2 turns
● Push the gas knobs in fully, and slowly turn counter-clockwise (to the left) to
the "HIGH" position.
● Then press and hold the black button of the igniter, there will be clicking and sparking until the burner
is lit.
● You can then adjust the knob to your desired setting.
● If the burner did not light, turn the knob back to the “OFF” position, wait 5 minutes for any gas to clear
away, and then repeat the lighting procedure.
● After using the grill, turn all burner knobs to the "HIGH" position and then push fully in and turn to the
"OFF" position.
● At once turn the valve on the LP Gas Cylinder OFF.
● IF the igniter does NOT light the burner, you can light it with a match or a piece of burning paper - hold
● Observe the proper burner flame - it should be a blue/yellow
color about 1/2” long.
the match or paper with the Match Holder attached at the back of the grill, put it through the openings
in the Cooking Grid and next to the Flame Tent covering.
Then follow the lighting procedure above.
31
MANUALLY LIGHTING THE GRILL
1. Open the Hood. IMPORTANT: Make sure control knob is turned "Off".
2. While holding a lit match near the burner, push the control knob in and turn counterclockwise to the High
position.
If burner goes out during operation, turn control knob to the "Off" position. Open hood and wait five minutes
before attempting to relight the grill to allow any accumulated gas to dissipate.
OPERATING INSTRUCTIONS - LP GAS