User Manual

26
45. ATTACHING THE WARMING RACK
Parts Required:
1 x Warming Racks (#5)
1 x Charcoal Lid
1 x Charcoal Main Chamber
2 x M6x3
0mm screw (#M)
Installation:
•Screw 1x M6x30 screw (#M) through the
Charcoal Lid from the outside, position 1pc
Warming Rack to the charcoal grill so that
the bolt is going through the wire loop See
Fig 45.1 & Fig.45.2
Then align the wire loop on the opposite
end of the Warming Rack with the opposite
Lid hole and insert 1x M6x30 screw (#M).
Insert the wire legs into the holes of the
Charcoal Main Chamber
See Fig. 45.3
Fig.45.1
46. PLACING COOKING GRIDS INTO
THE COOKING GRID SUPPORTS
Parts Required:
4 x Cooking Grids (#30)
Installation:
•Place four Cooking Grids (#30) into
the Cooking Grid Support
See Fig.46
47. INSERTING THERMOMETERS AND
BEZELS INTO THE LIDS
Parts Required:
2 X Thermometer (#1)
2 X Thermometer Bezel (#2)
1 x Gas Lid
1 x Charcoal Lid
Note: The Thermometer is supplied with
one fiber washer and one wing nut.
Installation:
•Unscrew the wing nuts and washers from
2pcs Thermometer first. Insert Thermometer
(#1) probe and Bezel (#2) through the
mounting hole in the top of the Gas Lid
Assembly. From the inside of the lid, place
fiber washer and wing nut onto the mounting
thread pole and tighten by hand
See Fig.47
•
Repeat the same step for Charcoal Lid.
Fig.46
Fig.47
Fig.45.2 Fig.45.3