User Manual

23
37. MOUNTING THE CHARCOAL TRAY
LIFTING SYSTEM TO THE BACK SIDE
OF CHARCOAL MAIN CHAMBER
Parts Required:
1 x Charcoal Tray Lifting System (#12)
1 x Charcoal Main Chamber
4 x M6x10mm screws (#D)
Installation:
•Mount the Charcoal Tray Lifting System
(#12) to the back side of Charcoal Main
Chamber
•Use: 4 x M6x10 screws (#D)
See Fig.3
Fig.37
LIFT HANDLE ASSEMBLY TO THE “U”
BRACKET ON THE BACK PANEL OF
CHARCOAL MAIN CHAMBER
Parts Required:
1 x Charcoal Tray Lift Handle
Assembly (#20)
1 x Charcoal Main Chamber
2 x Hinge Pin (#K)
2 x R Clip (#L)
Fig.38.1
Fig.38.3 Fig.38.4
Twist tie
should be taken
out after
assembly.
--------------------
Installation:
Slide Charcoal Tray Lift Handle Assembly
through the adjusting slot and through the
hole of the inside plate. Align the hole in the
end of the Lift Handle with the holes in the
“U” shaped bracket located at the back of
the Charcoal Main Chamber.
See Fig. 38.1 & Fig.38.2
Join the Lift Handle and the “U” shaped
Bracket by inserting a Hinge pin.
See Fig. 38.3.
Next insert an “R” Clip (#L) through the
hole in the Hinge Pin (#K). Attach the Lift
Handle to the Lift System by inserting a
Hinge Pin through the “U” shaped Lift Arm
and the hole in the center of the Lift Handle.
See Fig. 38.4.
Insert a “R” Clip (#L) through
the hole in the Hinge Pin
(#K). You should now be
able to adjust the Charcoal
Tray Lifting System to your
desired height by moving
the Lift Handle to the
.38.2
left and then raising or
lowering it.
Note: Gas lid needs to be closed prior to
assembly.
38. ATTACHING THE CHARCOAL TRAY
Fig.38.2