User Manual

16
19. ATTACHING THE TEMPERATURE
SENSOR INSIDE THE SMOKER CABINET
Parts Required:
1 x Temperature Sensor
Installation:
•Insert the Smoker Temperature Sensor
through the hole on the top of Smoker
Cabinet.
Next attach it into the clip which is
located inside top area of the Smoker
Cabinet.
see Fig.19.1, Fig.19.2 and Fig.19.3.
Fig.19.1
20. ATTACHING ELECTRIC WIRES
ONTO TWO CLIPS NEAR THE SMOKER
CABINET, ATTACHING THE GAS AND
CHARCOAL CABINET ASSEMBLY
ONTO THE CART ASSEMBLY
Parts Required:
1 x Electric Wires
1 x Electric Wires Male Socket
(end of the Electric Wires)
1 x Electric Wires Female Socket
1 x Gas and Charcoal Cabinet with Lids
Assembly (#13)
1 x Cart Assembly
8 x M6x15mm Screw (#A)
4 x M6x10mm Screw (#D)
Installation:
Note: The Main Chamber must be lined
up to the Trolley.
Fig.19.2
Fig.20.1
M6x10mm
---------
M6x15mm
------
------
M6x15mm
---------
Temperature sensor
-------------------------
Inside top area of
Electric Smoker
-------------
Regulator
---------------------
• Carefully open the lids, attach Gas and
Charcoal Cabinet Assembly (#13) to the
Cart Assembly
Use: 8pcs M6x15mm screws (#A) and 4 x
M6x10mm Screw (#D)
see Fig.20.1, Fig.20.1a, Fig.20.1b
Note: Fix 4pcs M6x10mm screws (#D)
on inside first, then fix the other 8pcs
M6x15mm screw (#A) later. Regulator
can be taken out at this stage for later
assembly.
• Attach the Electric Wires onto two clips
near the Smoker Cabinet from the lower
area of charcoal grill side and then attach
the Electric Wires Male Socket (end of the
Electric Wires) to the Female Socket which
is located on the back of Bottom Table
See Fig 20.2 and Fig.20.3
Fig.20.2
Fig.20.3
Electric
Wires
---------------
Male Socket
------
Female
Socket
-------
View hole for leg
screws assembly
---------------------
View hole for leg
screws assembly
------------------
Fig.20.1a
Fig.20.1b
---------
View
hole
for leg
screws
------
Fig.19.3