User Manual

15
16. MOUNTING THE SMOKER DOOR
HINGES TO THE SMOKER DOOR
Parts Required:
2 x Smoker Door Hinges (#50)
1 x Smoker Door (#40)
8 x M4x8mm White Zn Screws (#G)
Installation:
• Mount two Smoker Door Hinges (#50) to
the Smoker Door (#40).
Use: 8 x M4x8mm (#G)
see Fig. 16
Fig.16
17. MOUNTING THE SMOKER DOOR
WITH HINGE TO THE LOWER CABINET
ASSEMBLY
Parts Required:
1 x Smoker Door (#40)
1 x Lower Cabinet Assembly (#46)
8 x M4x8mm White Zn Screws (#G)
Installation:
• Mount Smoker Door (#40) with Hinge
assembly to Lower Cabinet Assembly (#46).
Use: 8 x M4x8mm (#G)
see Fig.17
18. PREPARATION OF ATTACHING THE
GAS AND CHARCOAL CABINET
ASSEMBLY ONTO THE CART ASSEMBLY
Parts Required:
1 x Gas and Charcoal Cabinet with Lids
Assembly (#13)
1 x Cart Assembly
Installation:
• Carefully put the main chamber on the top
of smoker body and then remove the twist
tie. Pull out the smoker electric wires and
smoker temperature wire/sensor from the
back side of Control panel first, then place
the electric wires toward back and place the
temperature wire and sensor toward front
see Fig.18.1
Attention: Do not pinch or sandwich the
electric wires and/or temperature wire
sensor during the assembly.
Fig.18.1
Fig.17
Fig.18.2
------ Cart Assembly
-----------
Correct
Direction
Twist tie
---------------
Temp sensor
-----------
Electric
wires
------------