User Manual

14
13. SLIDE THREE DIFFERENT
SMOKER COOKING GRIDS INTO THE
SMOKER CABINET ASSEMBLY
Parts Required:
1 x Smoker Cooking Grid (Large) (#33)
1 x Smoker Cooking Grid (Middle) (#34)
1 x Smoker Cooking Grid (Small) (#35)
1 X Smoker Cabinet Assembly (#32)
Installation:
•Slide Smoker Cooking Grid (Large)(#33),
Smoker Cooking Grid (Middle)(#34) and
Smoker Cooking Grid (Small)(#35) into the
Smoker Cabinet Assembly (#32)
see Fig.13
Fig.13
14. MOUNTING THE SMOKER DOOR
HANDLE AND LARGE HANDLE
STAND-OFF TO THE SMOKER DOOR
Parts Required:
1 x Smoker Door Handle (#38)
2 x Large Handle Standoffs (#7)
1 x Smoker Door (#40)
4 x M6x35mm Screws (#E)
Installation:
• Mount one Smoker Door Handle (#38) and
2 Large Handle Standoffs (#7) to
the Smoker Door (#40)
Use: 4 x M6x35mm (#E)
see Fig.14.1 & Fig.14.2
Note: Slots on both side of Smoker Door
Handle must be inserted into the
embossed area on inside area of Handle
Stand-off as Fig 14.1 shown.
15. INSERTING THERMOMETER INTO
THE SMOKER DOOR ASSEMBLY
Parts Required:
1 X Smoker Thermometer (#39) 1 x
Smoker Door Assembly (#40)
Note: The Thermometer is supplied
with one fiber washer and one wing
nut.
Installation:
•Insert Smoker Thermometer (#39) probe
through the mounting hole in the front of the
Smoker Door Assembly (#40). From the
inside of the door, place fiber washer and
wing nut onto the mounting thread pole and
tighten by hand and do not over tighten.
see Fig.15
Fig.15
Fig.14.1
Fig.14.2
#33 ---------
#34 --------
#35 ---------
#7.1(L) ------
------ #7.2(R)