Instructions / Assembly

6.      

Parts Required:

1 x LP Tank Barrier Bar (O)

2 x Screw (AA)

Installation:

• Attach the LP tank barrier bar (O) diagonally to the cart back panel (I)

and the cart base (W) using 1 screw (AA) at each end.

NOTE: The threaded end of the LP tank barrier bar should point to

the cart back panel, fastening from the outside of the cart.

7.     

Parts Required:

1 x Cart Support Beam (X)

4 x Screw (CC)

Installation:

• Attach the cart support beam (X) to the left and right side cart panels

(P and B1) using 4 screws (CC).

NOTE: The magnets on the cart support beam (X) should be facing

outward, and the holes should face downward while assembling.

8.     

Parts Required:

1 x Cart Support Brackets (U)

4 x Screw (AA)

Installation:

• Attach the cart support brackets (U) to the corners of the cart support

beam (X) and each side cart panels (P and B1) using 4 screws (AA).

9.     

Parts Required:

1 x Cart Heat Shield (T)

4 x Screw (AA)

Installation:

• Attach the cart heat shield (T) to the cart back panel (I) using 2 screws

(AA). Ensure the heat shield installs under the lip of the cart back

panel (I) as shown in illustration.

• Next, attach the cart heat shield (T) to the cart support beam (X) using

2 screws (AA). Ensure the cart heat shield (T) installs on top of the lip

of the cart support beam (X).