Assembly Instructions

ENGLISH
7
 
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws completely
until all screws for that step have been installed. Hardware combination involving a locking washer and washer should be
installed with the locking washer closest to the head of the screw.
1.      
Parts Required:
1 x Main Barrel
(#8)
2 x Left Leg (#19)
2 x Right Leg (#21)
16 x Screw (#A)
16 x Washer (#B)
16 x Locking Washer (#C)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit. Lay
the main barrel on its side, hopper end pointed upward, on the cardboard.
Note illustration.
• Mount one leg with wheel axle to the floor end of the main barrel using
four screws, locking washers, and washers, through the four pre-drilled
holes. Repeat installation for second leg with wheel axle.
NOTE: The two holes on the other leg remain unused.
• Mount one left leg to the hopper end of the main barrel using four screws,
locking washers, and washers, through the four pre-drilled holes. Repeat
installation for second left leg.
 
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack after
removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before assembly, then
review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to assemble. Shipping damage
is not covered under warranty. Contact your dealer or Pit Boss Customer Service for parts: Monday through Sunday, 4am - 8pm PST (EN/
FR/ES).
[e-mail] | Toll-Free: 1-877-303-3134 | Toll-Free Fax: [phone]
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and level.
Tools not included.
1


