Assembly Instructions

ENGLISH

9.    

Parts Required:

1 x Grease Bucket

(#14)

Installation:

• Place the grease bucket on the spout hook on the end of the main barrel.

Ensure it is level to avoid grease spills. The unit is now completely assembled.

10.     

NOTE: Before plugging your Pit Boss into any electrical outlet, ensure the

temperature dial is in the OFF position.

•

 

This appliance requires 110 volt, 60hz, 275w, 5 amp service. It must be a

3-prong grounded plug. Ensure grounded end is not broken off before use.

The control uses a 5 amp, 120 volt, fast-blow fuse to protect the board from

the igniter.

•

 

This appliance will work on most GFCI outlets, with a recommended size

of 15 amp service. If your GFCI outlet is highly sensitive to power surges,

it will likely trip during the start-up phase of operation. During the start-

up phase, the igniter draws 200-700 watts of electricity which can be too

much power for a GFCI outlet to handle. Each time it trips, it increases in

sensitivity. If the GFCI keeps tripping, replace the outlet or change to a non-

GFCI outlet.

•

  

Disconnect the igniter from the main wiring harness. Use the manual start-

up procedure. A Pit Boss unit can operate using a 12 volt, 100 watt inverter

plugged into your automobile outlet. To use the automatic igniter, it is

recommended to use a minimum of a 1000 watt inverter.

IMPORTANT: Disconnect unit from power source when not in use.

 ,

5 