User Manual

PePWave Surf Series User Manual
Page 5
3.2 Hardware Setup
3.2.1 Surf Indoor Series
1. Attach the provided antenna to the left most antenna connector
2. Connect the LAN port to the computer’s Ethernet port with an Ethernet cable.
3. Connect the end of the included power adapter to the power socket (labeled “DC 5V”)
on PePWave Surf.
4. Power on the power adaptor.
3.2.1 Surf Outdoor Series
Please follow the installation guide to set up AP 200/400-X, PolePoint 400-X, Surf 400-DX
3.3 LED Description
3.3.1 Surf Indoor Series
LED Color Status Description
Green On Power is on
Power
Off Power is off
Green Solid Received signal is Excellent, Very Good and Good
Green Blinking Received signal is Low
Amber Blinking Received signal is Very Low
Amber Solid No wireless signal is detected
Status
Off Booting up / Upgrading firmware
Green On Ethernet is connected
Green Blinking Sending/Receiving data
LAN
Off Ethernet is not connected