PISMO LABS TECHNOLOGY peplink PEPWAVE Wireless Product : Users Manual : Page 18

FCC & IC Requirements for Operation in the United States and Canada (for MAX BR1

Mini)

FCC ID : U8G-P1930LITER6

FCC 15.21: The changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

RF exposure warning: This equipment must be installed and operated in accordance with

provided instructions and the antenna(s) used for this transmitter must be installed to provide a

separation distance of at least 20 cm from all persons and must not be co-located or operating

in conjunction with any other antenna or transmitter. End-users and installers must be provide

with antenna installation instructions and transmitter operating conditions for satisfying RF

exposure compliance.

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely

to cause harmful interference in which case the user will be required to correct the interference

at his own expense.

IC Warning:

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,

Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to

the following two conditions

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause

undesired operation of the device.

Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence.

L'exploitation est autorisee aux deux conditions suivantes

1. l'appareil ne doit pas produire de brouillage, et

2. l'utilisateur de l'appareil doit accepter tout brouillage radioelect rique subi, meme si le

brouillage est susceptible d'en compromettre le fonctionnement.