User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 94 Copyright @ 2011 Pepwave
18.6 UPnP / NAT-PMP
The table that shows the forwarded ports under UPnP and NAT-PMP protocols is located at Status >
UPnP / NAT-PMP:
This section appears only if you have enabled the function of UPnP / NAT-PMP as mentioned in Section
13.2.
Click the button
to delete the single UPnP / NAT-PMP record in its corresponding row. To delete all
records, click Delete All on the right-hand side below the table.
Important Note
UPnP / NAT-PMP records would be deleted immediately after clicking the button or Delete All
without the need to click Save or Confirm.
18.7 Event Log
Event Log information is located at Status > Event Log:
The log section displays a list of events that has taken place on the Pepwave MAX unit. Click the
Refresh button to retrieve log entries again. Click the Clear Log button to clear the log. Select 50, 100,
or all to show the corresponding number of events in the log.