User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 92 Copyright @ 2011 Pepwave
18.2 Active Sessions
Information on Active Sessions is at Status > Active Sessions:
This Active Sessions section displays the active inbound / outbound and UDP / TCP sessions of each
WAN connection on Pepwave MAX.
A filter is available to help sort out the active session information. Enter a keyword in the field or check
one of the WAN connection boxes for filtering.
18.3 Client List
The client list table is located at Status > Client List. It lists DHCP client IP addresses, their Names
(retrieved from DHCP reservation table or defined by users), current Download and Upload rate and
MAC addresses that the Pepwave MAX has offered IP addresses to since it is powered up. Network
Name (SSID) and Signal refers to the information about Wi-Fi AP, which is the name of the Network and
its signal strength. Clients can be imported into DHCP Reservation table by clicking the
button on
the right-most column. Further update the record after the import by going to Network > LAN.
If PPTP Server in section 17.1 is enabled, you may see the corresponding connection name would be
listed in the field of Name.