User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 86 Copyright @ 2011 Pepwave
SNMP Community Settings
Community Name
This setting specifies the SNMP Community Name.
Allowed Source
Subnet Address
This setting specifies a subnet from which access to the SNMP server is
allowed.
Enter subnet address here (e.g. 192.168.1.0).
Allowed Source
Subnet Mask
This setting specifies the subnet mask that corresponds to the subnet
specified via Allowed Source Subnet Address (e.g. 255.255.255.0).
To define a user name for SNMPv3, click Add SNMP User in the SNMPv3 User Name table, upon which
the following screen is displayed:
SNMPv3 User Settings
User Name
This setting specifies a user name to be used in SNMPv3.
Authentication
Protocol
This setting specifies via a drop-down menu the one of the following valid
authentication protocols:
• NONE
• MD5
• SHA
Authentication
Password
This setting specifies the authentication password, and is applicable only if the
MD5 or SHA authentication protocol is selected.
Privacy Protocol
This setting specifies via a drop-down menu the one of the following valid privacy
protocols:
• NONE
• DES
Privacy Password
This setting specifies the privacy password, and is applicable only if the DES
privacy protocol is selected.