User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 78 Copyright @ 2011 Pepwave
Read-only User
Name
It is set as user by default and is not customizable.
User Password
This field allows you to specify a new user password. Once the user password
is set, the feature of read-only user will be enabled.
Confirm User
Password
This field allows you to verify and confirm the new user password.
Web Session
Timeout
This field specifies the number of hours and minutes that a web session can
remain idle before the balance terminates its access to Web Admin Interface.
By default, it is set as 4 hours.
Authentication by
RADIUS
With this box is checked, Web Admin will authenticate using an external
RADIUS server.
Authenticated users are treated as "admin" users with full read-write
permission. Local "admin" and "user" accounts will be disabled. When the
device is not able to communicate with the external RADIUS server, local
accounts will be enabled again for emergency access.
Authentication options will be available once this box is checked.
Auth Protocol
This specifies the authentication protocol used. Available options are MS-
CHAP v2 and PAP.
Auth Server
This specifies the access address of the external RADIUS server.
Auth Server Secret
This is the secret for accessing the RADIUS server.
Auth Timeout
This option specifies the time value for authentication timeout.
Accounting Server
This specifies the access address of the external Accounting server.
Accounting Server
Secret
This is the secret for accessing the Accounting server.
Network Connection
This option is for specifying the network connection which will be used for
authentication connection. Users can choose from LAN, WAN and VPN
connections.
Security
This option is for specifying the protocol(s) through which the Web Admin
Interface can be accessible:
HTTP
HTTPS
HTTP/HTTPS
Web Admin Port
These fields are for specifying the port number at which the Web Admin
Interface can be accessible.
Web Admin Access
This option is for specifying the network interfaces through which the Web
Admin Interface can be accessible:
LAN only
LAN/WAN
If LAN/WAN is chosen, a WAN Connection Access Settings form will be
displayed.