User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 76 Copyright @ 2011 Pepwave
17 System Settings
17.1 Admin Security
There are two user accounts available for accessing the Web Admin. Usernames are admin and user.
They represent two user levels - admin has full administration access, while user is a read-only account.
The read-only account can only access the device's status information and cannot make any change on
the device.
A web login session will be logged out automatically when it has been idled for a longer time than
the Web Session Timeout. The default timeout is 4 hours 0 minute. Before the session expires, you may
click the Logout button in the Web Admin to exit from the session.
For security reasons, after logging in to the administration interface at the first time, changing the
administrator password is recommended.
Configuring the administration interface to be accessible only from the LAN can further improve system
security.
Administrative Settings configuration is located at System > Admin Security:
Admin Account UI User Account UI