User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 70 Copyright @ 2011 Pepwave
Upon clicking Save after entering required information, the following screen appears.
To create an additional firewall rule, click Add Rule and repeat the above steps.
To reorder a rule’s position, just drag the rule by holding the left mouse button, move it to the desired
position, and place it by releasing the mouse button.
To remove a rule, click
.
Rules are matched from top to the bottom. If a connection matches any one of the upper rules, the
matching process will stop. If none of the rules is matching, the Default rule will be applied.
By default, the Default rule is set as Allow for both outbound and inbound accesses.
Tip
If the default inbound rule is set as Allow for NAT enabled WANs, no inbound Allow firewall rules will
be required for inbound Port Forwarding and inbound NAT Mapping rules. However, if the default
inbound rule is set as Deny, a corresponding Allow firewall rules will be required.