User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 7 Copyright @ 2011 Pepwave
3.1.5 Outbound Policy
Link load distribution per TCP/UDP service
Persistent routing for specified source and/or destination IP addresses per TCP/UDP service
Traffic Prioritization and DSL optimization
Prioritize and route traffic to VPN tunnels with Priority and Enforced algorithms
3.1.6 QoS
Quality of Service for different applications and custom protocols
User Group classification for different service levels
Bandwidth usage control and monitoring on group- and user- level
Application Prioritization for custom protocols and DSL optimization
3.2 Other Supported Features
User-friendly web-based administration interface
HTTP and HTTPS support for Web Admin Interface
Configurable web administration port and administrator password
Firmware upgrades, configuration backups, Ping, and Traceroute via Web Admin Interface
Remote web based configuration (via WAN and LAN interfaces)
Time server synchronization
SNMP
Email notification
Read-only user for Web Admin
Authentication and Accounting by RADIUS server for Web Admin
Built-in WINS Servers
Syslog
SIP passthrough
PPTP packet passthrough
Event Log
Active Sessions
Client List
WINS Client List
UPnP / NAT-PMP
Real-Time, Daily and Monthly Bandwidth Usage reports and charts