User Manual

http://www.pepwave.com 69 Copyright @ 2011 Pepwave
Destination IP &
Port
This specifies the destination IP address(es) and port number(s) to be matched
for a firewall rule.
A single address, or a network, can be specified as the Source IP & Port setting,
as indicated with the following screenshots:
In addition, a single port, or a range of ports, can be specified for the Source IP &
Port setting.
Action
This setting specifies the action to be taken by Pepwave MAX upon encountering
traffic that matches the both of the following:
• Source IP & Port
• Destination IP & Port
With the value of Allow for the Action setting, the matching traffic passes through
Pepwave MAX (to be routed to the destination).
If the value of the Action setting is set to Deny, the matching traffic does not pass
through Pepwave MAX (and is discarded).
Event Logging
This setting specifies whether or not to log matched firewall events.
The logged messages are shown on the page Status > Event Log.
A sample message is as follows:
Aug 13 23:47:44 Denied CONN=Ethernet WAN SRC=20.3.2.1
DST=192.168.1.20 LEN=48 PROTO=TCP SPT=2260 DPT=80
• CONN: The connection where the log entry refers to
• SRC: Source IP address
• DST: Destination IP address
• LEN: Packet length
• PROTO: Protocol
• SPT: Source port
• DPT: Destination port