User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 62 Copyright @ 2011 Pepwave
NAT Mapping Settings
LAN Host
This is the IP address of the host on the LAN that the system should map the
selected connection IP address correspondences.
Inbound
Mappings
This setting specifies the WAN connections and corresponding WAN-specific
Internet IP addresses on which the system should bind on. Any access to the
specified WAN connection(s) and IP address(es) will be forwarded to the LAN
Host.
Note 1: Inbound Mapping is not needed for WAN connections in IP forwarding
mode.
Note 2: Each WAN IP address can be associated to one NAT Mapping only.
Outbound
Mappings
This setting specifies the IP address of each WAN connection to be used for any
outgoing traffic originating from the LAN Host.
Note 1: If you do not want to use a specific WAN for outgoing accesses, you
should still choose default here, then customize the outbound access rule in the
Outbound Policy section.
Click Save to save the settings when configuration has been completed.
Important Note
Inbound firewall rules override the Inbound Mapping settings.