User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 60 Copyright @ 2011 Pepwave
Range Mapping: traffic that is received by Peplink Balance via the specified protocol at
the specified port range is forwarded via a different port to the servers specified by the
Servers setting.
Inbound IP
Address(es)
This setting specifies the WAN connections and Internet IP address(es) from
which the service can be accessed.
It is required to select at least one IP address.
Server IP
Address
This setting specifies the LAN IP address of the server that handles the requests
for the service.
12.2 UPnP / NAT-PMP Settings
UPnP and NAT-PMP are network protocols which allow a computer on the LAN to automatically configure
the router to allow parties on the WAN to connect to itself. In this way, the process of inbound port
forwarding is automated.
When a computer creates a rule using these protocols, the specified TCP/UDP port of all WAN
connections' default IP address will be forwarded.
Check the corresponding box(es) to enable UPnP and/or NAT-PMP. Enable these features only if you
trust the computers on the LAN.
A table listing all the forwarded ports under these two protocols can be found at Status > UPnP / NAT-
PMP.