User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 58 Copyright @ 2011 Pepwave
12 Port Forwarding
12.1 Port Forwarding Service
Pepwave MAX can act as a firewall that blocks, by default, all inbound access from the Internet. By using
Port Forwarding, Internet users can access the servers behind Pepwave MAX.
Inbound Port Forwarding rules can be defined at Advanced > Port Forwarding:
To define a new service, click the Add Service button, upon which the following appears:
Port Forwarding Settings
Enable
This setting specifies whether the inbound service rule takes effect.
When Yes is selected, the inbound service rule takes effect. If the inbound traffic
matches the specified IP Protocol and Port, action will be taken by Pepwave
MAX based on the other parameters of the rule.
When No is selected, the inbound service rule does not take effect. Pepwave
MAX will disregard the other parameters of the rule.
Service Name
This setting identifies the service to the System Administrator.
Valid values for this setting consist only of alphanumeric and the underscore “_”
characters.