User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 57 Copyright @ 2011 Pepwave
Tip
The round trip time of a “6M down / 640k up” link can be higher than that of a “2M down / 2M up” link.
It is because the overall round trip time is lengthened by its lower upstream bandwidth despite of its
higher downlink speed. Therefore this algorithm is good for two scenarios:
• All WAN connections are symmetric; or
• A latency sensitive application requires to be routed through the lowest latency WAN
regardless the WAN’s available bandwidth.
11.2.8 Expert Mode
Expert Mode is also available for advance users. Click the help test balloon and click the link turn on
Expert Mode to switch on the feature.
Under Expert Mode, a special rule - "Site-to-Site VPN Routes" is displayed on the Custom Rules table. It
represents all Site-to-Site VPN routes learned from remote VPN peers. By default, this bar is on the top
of all custom rules. That means traffic for remote VPN subnets will be routed to its corresponding VPN
peer. You can create custom Priority or Enforced rules and move them above the bar to override the
Site-to-Site VPN Routes.
Upon disabling the Expert Mode, all rules above the bar will be deleted.