User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 52 Copyright @ 2011 Pepwave
New Custom Rule Settings
Service Name
This setting specifies the name of the custom rule.
Enable
This setting specifies whether the outbound traffic rule takes effect.
With an Enable value of Yes, the rule takes effect: traffic is matched, and actions
are taken, by Pepwave MAX based on the other parameters of the rule.
With an Enable value of No, the rule does not take effect: Pepwave MAX
disregards the other parameters of the rule.
Source
This setting specifies the source IP Address, IP Network or MAC Address for
outbound traffic that matches the rule.
Destination
This setting specifies the destination IP Address or IP Network for outbound
traffic that matches the rule.
Protocol and Port
This setting specifies the IP Protocol and Port of outbound traffic that matches
this rule. You may select some common protocol from the Protocol Selection
Tool drop-down menu.
Algorithm
This setting specifies the behavior of Pepwave MAX for the custom rule.
One of the following values can be selected:
• Weighted Balance
• Persistence
• Enforced
• Priority
• Overflow
• Least Used
• Lowest Latency
The upcoming sections present the details of the listed algorithms.